Adhesive Machines

1 pcs. Multimixer - type LMX 4-2

GLP sandwich-press

Press for sandwich plate production like caravans or partition walls

GLP Veneer press

Sennerskov hydraulic through-feed press, model GLP-64150-1-6 EW

High pressure press

Sennerskov High Pressure Press line Very solid all-welded frame construction for carrying press plans, upper as well as lower. Each frame is prepared in one setup that secures a parallel installation of the press plans. The total number of press frames is mounted on longitudinal steel beams in the bottom and top spacers, which are screwed or welded on dependent on the length of the press. Solid steel plates, cross-drilled channels to ensure a steady distribution of heating/cooling. Pressure cylinders are made in a very strong dimension. Cylinder shaft is in hard chromium plating and thus has an extended service life. The cylinders are equipped with scraper rings to secure against penetration of dust particles. The throughfeed transportation is central, driven by a strong feed shaft. This feed shaft is mounted with chain drive connected to the throughput chain wheel, and thereby a parallel pull is created.

Hydraulic arbor press

Very solid all-welded frame construction for carrying press plans, upper as well as lower. Each frame is prepared in one setup that secures a parallel installation of the press plans.

Hydraulic press

Sennerskov presses are manufactured for all purposes in many variations Up to 4.4 m width Cycle time 10 sec. + pressing time Heating by water, oil or steam Single/multiple opening Through-feed/shuttle feed Presses for wood, rubber, plastic, metal